Specifications

Projector Installation and Setup
Entero HB Rear-Access Cube Installation and Setup Manual 32
020-101007-04 Rev. 1 (12-2014)
When the LED display (located on the electronics module) shows ON it indicates power is
enabled.
2. To display the internal geometry test pattern, on the remote press Test
once.
The test image should fill the screen. If not, make a coarse adjustment using the 6-axis adjuster
before adjusting the lens. See Adjust image geometry using the 6-axis adjuster on page 35.
i
• When the Auto Power setting is set to Off, the LED displays Standby. To power on, press the
Power button on the remote control, followed by the up arrow.