Specifications

Entero HB Rear-Access Cube Installation and Setup Manual 33
020-101007-04 Rev. 1 (12-2014)
Adjust the Image
Complete the adjustments outlined in this section for each display, as required. Achieve the best
results possible before moving on to the next adjustment.
Image adjustments include:
• 6–axis adjustment: Adjusts image geometry to best match the screen perimeter.
• Lens focus adjustment: Adjust for best image focus on the screen.
• Mirror adjustment (only if required): Adjusts fine geometry around the perimeter of the screen.
Adjustment tips
• In a multiple-cube display, adjust the center cube first, and then adjust the adjacent cubes to
match, working out and up from the center.
• Adjust one display at a time until the entire wall is adjusted.
• Make a rough adjustment of the 6-axis adjuster, focus the image using the focus adjustment
knob on the lens, and lock the focus by tightening the focus adjustment knob. Then make a fine
adjustment to the 6-axis adjuster.
• Do not over-adjust the knobs on the 6-axis adjuster. A slight resistance during adjustment
indicates the end of the adjustment range for that knob.
• Use small 1/4 – 1/2” turns on the 6-axis adjuster to achieve the desired image. This will aid in
returning the adjuster back to an original position in the event you lose track of your
adjustments and want to start over.
• The adjuster is shipped in nominal position. Nominals are marked; a flashlight may assist in
locating the marks.
Adjust lens focus
Notice. Failure to comply with the following may result in property damage.
• Do not use tools to adjust focus and BFL. Failure to comply may result in equipment damage.