Specifications

Adjust the Image
Entero HB Rear-Access Cube Installation and Setup Manual 35
020-101007-04 Rev. 1 (12-2014)
Adjust image geometry using the 6-axis adjuster
The optical module is mounted on a 6-axis adjuster. Use the adjuster controls to adjust image
geometry: position, keystone, zoom, and tilt. Adjustment knobs are color-coded. The 6–axis
adjustment label on the product illustrates the function of each. Before making adjustments, make
sure the lock screws for each adjustment knob are loosened. Use the 5 mm hex key provided to
loosen the M6 lock screws and a 2 mm hex key (not provided) to loosen the collar lock screws.
Tighten all lock screws after image adjustments are complete.
The orientation of the projector in relation to the screen changes the effect of the knob
adjustments. Vertical (lens up) is the default installation.
1. Work from the back of the display cube. Make sure you can see all 4 sides of the image on the
inside of the screen.
i
• If mirror adjustments are necessary do so only after you have completed this procedure.
• Start with the displays in the center cubes in the bottom row and work towards the end of the row.
Red Adjustment Knob: Adjust tilt.
Blue Adjustment Knob: Adjust the vertical position.
White Adjustment Knob: Adjust keystone.
Yellow Adjustment Knob: Adjust keystone.
Orange Adjustment Knob: Adjust the horizontal position.
Green Adjustment Knob: Adjust zoom.
unlocks
zoom control on
rear side of adjuster