Specifications

Adjust the Image
Entero HB Rear-Access Cube Installation and Setup Manual 38
020-101007-04 Rev. 1 (12-2014)
the adjustment screws to adjust the mirror in both directions, meaning the mirror can be pushed in
or pulled out.
Adjust the mirror
1. Loosen each of the thumbscrews. Turn each thumbscrew in either direction until you feel
resistance. This is the neutral position.
2. Turn the thumbscrews, in either direction to move the image 1 to 2 pixels from any corner or
edge. Adjust the corners of the image first, then the edges.
For information on the adjustments required to troubleshoot specific image problems, see
Image geometry troubleshooting using the mirror on page 38.
Image geometry troubleshooting using the
mirror
The following examples illustrate what areas of the optical mirror to adjust to achieve the required
image.