Specifications

Entero HB Rear-Access Cube Installation and Setup Manual 42
020-101007-04 Rev. 1 (12-2014)
Configure the display
wall
The following section outlines the procedures that must be completed to connect the display wall
power, and to configure the display wall. This includes mapping and numbering the displays, and
connecting to the network. Each procedure includes the steps required to complete the task from
either the OSD or the WebUI.
Connect to power
This section describes the controls used for basic display operation once it is properly installed,
aligned, and configured by a Christie accredited service technician. You can access display controls
and settings with the standard IR remote, an iPad
®
, or with a laptop using the web interface.
Connect AC
Each display is supplied with a power cord appropriate for your region.
1. Plug one end of the power cord into the AC receptacle on the power module.
2. Plug the other end of the power cord into a grounded AC outlet.
Caution! Failure to comply with the following could result in minor or moderate injury.
• Make sure you are using a line cord, power plug and socket that meet the appropriate rating
standards. For details, see SXGA+ models on page 52, HD models on page 54, and WU models on
page 55.
• Do not use damaged line cords.
Caution! Failure to comply with the following could result in minor or moderate injury.
• Use only an AC supply within the specified voltage and power range. Do not attempt operation if
the AC power source is not within the rated voltage range, as specified on the license label, found
on the projector tray.
i
• Make sure the array is connected to a wall breaker with max. 20A.
• Can be connected to IT power distribution.