Specifications

Configure the display wall
Entero HB Rear-Access Cube Installation and Setup Manual 43
020-101007-04 Rev. 1 (12-2014)
Enable power
1. Flip the main Power switch on the power module to On.
It takes approximately 2 minutes for power to initialize.
2. When the LED display, located on the Electronic Module (EM) shows ON it indicates that power
is enabled.
When the Auto Power setting is set to Off, the LED display will display Standby. In this case,
press the Power button on the remote control, followed by the up arrow to power the product
On. For details, see Configure power settings in the Entero HB Software User Manual (P/N:
020-100981-xx).
Disable power
1. Using the remote, press the Power button, and then the down arrow button.
2. Wait until the LED display states that the system is in Standby mode.
3. Flip the main Power switch on the power module to Off.
4. Disconnect the line cord from the AC outlet.
Map and number the display
The mapping feature is used to physically map each of the displays to the layout of the array.
Mapping establishes easy selection and control of the display wall. It also sets the array up so that
displays continually monitor and manage color and brightness across the entire display wall.
Numbering is used to easily identify each of the displays in the wall.
From the OSD
1. To access the Main menu on the OSD, press Menu on the IR remote.
2. Select Display Configuration > Mapping and Numbering.
3. To access the Edit Mapping window, select Array.
4. Specify the array number and the XY coordinates of the display.
5. Specify the display number.
Alternatively, the WebUI offers an auto numbering function. Each projector must be given a
unique display number.
6. To return to the Mapping and Numbering menu, press Exit from the IR remote.
i
• When a display is mapped, all the wall and array settings are reset back to the defaults.