Specifications

Configure the display wall
Entero HB Rear-Access Cube Installation and Setup Manual 44
020-101007-04 Rev. 1 (12-2014)
From the WebUI
1. To display the Mapping mode window on each display in the array, press PIP on the IR remote.
Use this window to visualize where each display is located within its real environment and easily
map each display in the display wall.
2. To access the WebUI, enter the IP address of one of the displays in a browser.
3. From the WebUI, select Wall Configuration > Mapping.
4. In the Array section of the window assign a number to the array.
To create a new array, assign an unused array number.
To add displays to an existing array, enter an existing array number.
5. Enter the width and height of the display wall.
6. The assigned array number and a representation of the display wall appears in the Display Grid
section of the window.
7. Look up the MAC address of the display you want to map in the WebUI Detailed System Status
chart.
8. Select the display you want to map from the Detailed System Status chart. Once selected, the
bar is highlighted blue.
Typically, you will start with the display at the top–left corner of the display wall. Only one
display can be mapped at a time.
9. Click and drag the selected display from the Detailed System Status chart into the area of the
Display Grid that you want the display to be mapped to.
Select the display in the Detailed System Status chart and then click where you want to map
the display to in the Display Grid. The mapped display is illuminated green.
10. Repeat steps 8 and 9 for each display in the array.
11. To automatically number each display in the array, click Auto Numbering.
Once the numbering sequence is complete, the WebUI redirects to the Display Configuration
> Display Number window.
The Display Number window allows you to assign a number to the mapped displays
automatically, in sequence starting from the top–left of the array. Note that the Auto Number
selection can only be performed on mapped displays.
12. Select all displays in the array.
13. To bring up the Information window on each display, select Identify On.
Use this window to confirm that the number and array coordinates are correct.
14. If necessary, select an individual display from either the Detailed System Status chart or the
Display Grid, and manually enter the number in the User Display Number field.
i
• Auto Number identifies all displays in the array in sequence starting from the top–left of the array.
This feature is identical to Auto Numbering.