Specifications

Configure the display wall

Entero HB Rear-Access Cube Installation and Setup Manual 45

020-101007-04 Rev. 1 (12-2014)

Unmap the display

From the OSD

1. To access the Main menu on the OSD, press Menu on the IR remote.

2. Select Display Configuration > Mapping and Numbering.

3. Select Unmap this Display.

From the WebUI

1. Select Wall Configuration > Mapping.

2. Select the display to unmap in the Display Grid.

3. Click Delete.

The delete icon only appears after a display has been selected.

Configure network settings

From the OSD

1. To access the Main Menu on the OSD, press Menu on the IR remote.

2. Select Display Configuration > Networking.

3. Enter a valid and unique IP address for use on the network to which the display is currently

connected.

This address overwrites any previous IP address, such as the factory-defined display default. It

takes approximately 10 seconds for the display to respond at its new address.

4. Set the Subnet Mask for the IP address.

5. Set the IP address of the gateway used to reach any non-local IP addresses as the Default

Gateway.

From the WebUI

1. Select Display Configuration > Networking.

2. Select the desired display(s) either from the Detailed System Status section or the Display Grid,

or click Select All.

• MAC displays the unique MAC address assigned to the network.

• DHCP is enabled by default. DHCP should only be disabled if you want to manually enter an IP

address.

• If more than one display is selected, only DHCP can be enabled.

• To set a static IP address for the displays, each display must be configured individually.