Specifications

Entero HB Rear-Access Cube Installation and Setup Manual 7

020-101007-04 Rev. 1 (12-2014)

Introduction

This manual provides instructions for installing a Christie cube display system, which is comprised

of a cube enclosures, projection light engines, display screens, and cube pedestals. The manual is

intended for technicians with experience installing display systems. For information about installing

the projector in a non-Christie enclosure, contact your dealer.

Install the components of the Entero cube in the following order:

1. Install the pedestals.

See Install pedestals on page 11.

2. Install the cubes.

See Install display cube enclosures on page 16.

3. Install the screen on each cube.

See Determine the optimal gap between screens on page 19.

4. Install the projector.

See Projector Installation and Setup on page 24.

5. Adjust the image on the screen.

See Adjust the Image on page 33.

Additional resources

• Entero HB Software User Manual (P/N: 020-100981-xx)

• Entero HB RPMSP/RPMHD/RPMWU-LED02 Projector and Cube Serial Command Reference Guide

(P/N: 020-101355-xx)

To avoid personal injury or damage to the display system, read this information thoroughly before

installing the Entero HB pedestals, projectors, and cube enclosure.

• Read these instructions.

• Keep these instructions.

• Heed all warnings.

• Follow all instructions.

• Ambient temperature must stay below 35° C (95° F). For best performance and reliability, an

ambient temperature of less than 25° C is recommended.

• Keep the projector away from all devices radiating electromagnetic energy. For example, motors,

transformers, speakers, power amplifiers, and elevators.