Specifications
Introduction
Entero HB Rear-Access Cube Installation and Setup Manual 8
020-101007-04 Rev. 1 (12-2014)
• Entero HB RPMSP/RPMHD/RPMWU-LED02 Service Manual (P/N: 020-100982-xx)
• Installing a Projector into a Custom Structure with Direct Throw Orientation Instruction Sheet
(P/N: 020-101345-xx)
Safety precautions
Observe these important safety rules to avoid personal injury or damage to the projector or display
cubes:
Warning! Failure to comply with the following could result in death or serious injury.
• Tip Load! The maximum stacking limitation is five cubes high in a minimum two column display
wall. The display wall must be properly anchored anytime the wall is two rows or higher to prevent
tipping and provide stability. Use all the hardware provided to fasten the display cubes to the
support structure. See Secure the pedestal with anchor bolts on page 14 and Secure the cubes
with tie backs on page 19.
• Disconnect the AC cord before disconnecting any projector components.
Caution! Failure to comply with the following could result in minor or moderate injury.
• Do not look directly into the projector lens. The high brightness of this projector could cause
permanent eye damage. For protection, keep all projector shielding intact during operation.
• Lift equipment must be used to lift the display cubes into position on rows two or higher. A crew of
two or more can lift a display cube into position on the first row.
• Mount the projector in a Christie display cube or to a sturdy, flat surface that fits the entire
projector. Use all four mounting points to secure the projector to the surface.
• Always power down and disconnect/disengage all power sources to the projector before servicing
or cleaning.
Notice. Failure to comply with the following may result in property damage.
• Maintain a minimum clearance of 2.5 cm (1.0”) around the projector for air circulation and 7.5 cm
(3”) clearance for cable connections to the input panel. Insufficient clearance can cause the
projector to overheat during operation or place undue stress on source connections.
• This projector must be operated in an environment that meets the operating range specification, as
listed in Specifications on page 52.