Specifications

Entero HB Rear-Access Cube Installation and Setup Manual 9

020-101007-04 Rev. 1 (12-2014)

Cube Installation and

Setup

Christie pedestals

Christie pedestals (models PE50, PE67, PE70, PE70HD, PE72, or PE80) are recommended when you

install Christie display cubes (models CC50SX+, CC67SX+, CC70SX+, CC70HD, CC72WU, or

CC80SX+).

Stacking limitations

Stacking limitations apply to all the display cube models. Christie recommends either using tiebacks

or lag bolts to secure the display wall.

For details, see Secure the pedestal with anchor bolts on page 14 and Secure the cubes with tie

backs on page 19.

Notice. Failure to comply with the following may result in property damage.

• Only qualified installers should attempt installation of a Christie display wall.

• A clearance of 3 ft or more is recommended behind the display cubes for serviceability and

installation.

Caution! Failure to comply with the following could result in minor or moderate injury.

• Tip Load! The maximum stacking limitation is five cubes high in a minimum two column display

wall.

• The display wall must be properly anchored anytime the wall is two rows or higher to prevent

tipping and provide stability. Use all the hardware provided to fasten the display cubes to the

support structure. See Secure the pedestal with anchor bolts on page 14 and Secure the cubes

with tie backs on page 19.

• When stacking display cubes, they must be installed on a level surface. If the surface is not level,

the stacked cubes could tip over and cause damage to the cubes or personal injury.