User manual

BASIC OPERATION

CP2000-X User Manual 3-41

020-100031-01 Rev . 1 (03-2009)

Figure 3.26. Admin:Lamp Menu Functions

Table 3.10. Summary of Admin:Lamp

Menu Functions

ADMIN:LAMP MENU FUNCTIONS

Lamp Type Select which lamp is installed in the projector. Correct lamp type sets

the corresponding range of power available. NOTE: The lamp must be

OFF in order to set Lamp Type.

Footlamberts Calibration Activate each text box to automatically drive the lamp at its minimum

or maximum power. Record light measured at the screen for both

extremes—this defines a range of footlamberts possible. Light

readings (fL) appearing elsewhere in TPC will then be interpolated

from this range.

Cable Length Define the length of the high-current DC cables connected between

your lamp ballast and projection head. Adjustment range is 2-30m

(6½-100 ft.) in 1m increments.

NOTES: 1) For manual operation (i.e., non-automated). 2) In order to use the TPC

software originally shipped with the projector, the installer typically connects a

laptop and uses Christie’s DCP Librarian setup software to download all necessary

configuration files to the projector for use at the TPC.

To change to a new source—i.e., a new presentation or display—do the following

(See Figure 3.27):

 Make sure the CP2000 and TPC are both powered up and operating normally

 On the Touch Panel Controller (TPC), select the Main menu tab

 On the Main menu, press the desired channel button—the image will update

accordingly

Selecting a Displa



(Starting a Presentation)