Instruction manual

Installation and Setup
CP2215 Quick Start Guide 8
020-101295-01 Rev. 2 (05-2014)
6. Move the lens clamp to the locked position.
Install the Lamp
1. If the projector is operating, turn it off and allow it to cool a minimum of 15 minutes.
2. Turn the breaker switch for the projector off.
3. Disconnect the projector from AC power.
4. Put on your protective clothing, face shield, and gloves.
5. Insert the key in the lamp door lock, turn the key, and open the lamp door.
6. Loosen the 2 thumbscrews (A and B) and open the lamp access door.
This procedure should only be performed by a Christie accredited technician. High-pressure
lamp may explode if improperly handled. Always wear approved protective safety clothing
whenever the lamp door is open or when handling the lamp. Failure to comply results in
death or serious injury.