Instruction manual

Installation and Setup
CP2215 Quick Start Guide 16
020-101295-01 Rev. 2 (05-2014)
Activate Marriage
You must complete marriage to display encrypted content and to comply with the Digital Cinema
Initiatives (DCI) specification. You cannot complete marriage remotely. In addition, an authorized
employee must be physically present to verify that the anti-tamper seal on the firewall is unbroken,
the projector is unaltered, and to press the marriage button on the card cage faceplate.
1. Log on to the projector with marriage permissions. See Log On to the Projector on page 15.
2. Tap Menu > Service Setup > LD Marriage.
3. Complete the Marriage wizard.
4. Click Finish.
Add the Projector to a Network
1. On the touch panel controller (TPC), tap Menu > Login.
2. Select an administrator account in the Username list.
3. Enter a password in the Password field and then tap Login.
4. Tap Menu > Administrator Setup > Communications Configuration.
5. Complete these fields:
Field Description
Device Name The name of the projector.
IP Address The IP address of the projector.
Subnet Mask The subnet mask to which the IP address belongs.
Gateway The IP address for the network gateway.
Apply Applies Ethernet settings.
Serial Speed (Baud) The baud rate of the serial port. The default is 115200.
Enable SNMP Enables SNMP.
SNMP V2 / SNMP V3 The SNMP protocol type. Contact Christie technical support for the SNMP
V3 user ID and password.