Instruction manual

Installation and Setup
CP2215 Quick Start Guide 5
020-101295-01 Rev. 2 (05-2014)
Adjust Tilt and Level the Projector
The front-to-back and side-to-side tilt of the projector must not exceed 15 degrees.
1. Loosen the lock nut with a 3/4 in. or 19mm wrench.
2. Turn the adjustable feet on the bottom of the projector
clockwise or counter-clockwise 1/8th of a turn at a time to
move the projector up or down.
When adjusting two or more feet at once, always adjust
them the same amount. This keeps equal weight distribution
on all feet for stability.
3. Adjust the horizontal position of the projector.
4. Verify that the image is centered and parallel with the top of
the screen. If additional adjustments are required, repeat
steps 1 and 2.
5. Adjust lens offset, rather than extra projector tilt, if vignetting is not observed.
Install the Touch Panel Controller
For more information about the touch panel controller (TPC), see Touch Panel Controller in the
CP2215 User Manual.
1. Loosen the mounting arm on TPC.
2. Fit the TPC mounting arm over the ball joint (A) located on the rear panel of the projector.