User`s manual

Appendix E: OPTIONAL INPUT MODULES
E-2
RPMS, CS50 & CS70-D100U/UF User’s Manual
The RGB400 ALT Input Module may be installed in this projector, a Marquee Signal
Switcher, or a Marquee Case/Power Supply. The module receives analog RGB input
signals from computers or other RGB source devices. Video inputs are 75
Σ
terminated. Video outputs provide buffered loop-through to another display device.
RGB400ALT Features
◊ accepts 3, 4, or 5 wire RGB video (sync-on-green, composite sync, or
separate horizontal and vertical sync)
◊ BNC connectors for RGB signal inputs
◊ buffered loop-through video outputs
NOTE: The audio connectors are not functional.
The Composite/S-Video Input Module may be installed in this projector, with a
Marquee Signal Switcher. The module receives either composite video or S-video
input signals from tape or disk players (do not connect both types of signals
simultaneously). Video inputs are 75
Σ terminated. Video outputs are provided for
buffered loop-through to another display device.
Composite/S-video Features
◊ BNC connectors for composite RGB signals
◊ 4-pin mini-DIN connectors for S-Video signals
◊ buffered loop-through video outputs
NOTES: 1) This interface is not a decoder. NTSC, PAL, or SECAM signals must
connect to the video decoder installed at
INPUT 3 / INPUT 4. 2) The audio connectors
are not functional. 3) For use with this projector, do not connect both composite
video and S-video signals to the Composite / S-Video Input Module–connect one or
the other, even when plugged into a switcher.
The PC250 Analog Input Module may be installed in this projector, a Marquee
Signal Switcher or a Marquee Case/Power Supply. The module receives analog RGB
input signals from IBM PC compatibles or Macintosh computers. Video inputs are
75
Σ terminated. Video outputs are provided for buffered loop-through to another
display device.
RGB400
A
ctive Loop-Thru '
Input Module
38-80460
7
-x
x
Composite / S-Video
'
Input Module
38-804608-x
x
PC250 Analog
'
Input Module
38-804609-x
x