User`s manual

OPERATION
RPMS, CS50 & CS70-D100U/UF User’s Manual 3-7
Function Key
From presentation level, press
Func
followed by a 2-digit number to enable a specific
color or colors in the display. For example,
Func
6 4
will display only red and green
data,
Func
6 7
will display all colors data. The list of available color combinations is
shown below and also appears on the back of the IR remote keypad. Color enabling
can also be accessed through the menu system rather than these shortcuts.
Func
6 1
= Red
Func
6 2
= Green
Func
6 3
= Blue
Func
6 4
= Red and Green
Func
6 5
= Green and Blue
Func
6 6
= Red and Blue
Func
6 7
= All colors (
Exit
does the same thing)
NOTE: Once
Func
is pressed in presentation level, the projector will not respond to
non-numeric entry until 2 digits have been entered or until 5 seconds of inactivity
have elapsed.
Use of the
Func
key within the menu system is noted with the appropriate topic
elsewhere in Section 3. For example, press
Func
in the Channel Setup menu to enable
deletion or copying of a channel.
OSD* (On-screen display)
Press and hold
OSD
*
for approximately 1 second to toggle menus on or off (i.e.,
visible or invisible). Or press
OSD
*
followed immediately by
ON
or
OFF
to guarantee
the correct toggle direction (useful if you are unsure of the present status). Note that
invisible menus are fully functional.
NOTES: 1) With OSD on, you can still mute menus, error messages, slidebars, etc.
with the appropriate setting in the Preferences menu.
Help
Press
Help
for detailed information about any current menu and highlight. Press
Help
again to exit. From presentation level, press
Help
to access the General Help menu
consisting of Using Help, Setup, Keys, Source (Input) Selection, and Stat/Pwr LEDs.
Press
Exit
to leave General Help and return to presentation level.
Test
Press
Te s t
to display one of the available test patterns. Press
Te s t
again to display the
next available pattern in the sequence.
Te s t
will exit after the last pattern, or press
Exit
at any time to remove the current test pattern from the screen and return to
presentation level.
NOTE: For a complete list of all test patterns, see the Geometry menu description
later in Section 3.
Display *
Use
DisplayDisplay
*
to hide the current menu. Press and hold
DisplayDisplay
*
for approximately 1
second to toggle on or off with a single key press. Or quickly press and release
Func
OSD
*
Help
Te s
t
DisplayDisplay
*