User`s manual

OPERATION
RPMS, CS50 & CS70-D100U/UF User’s Manual 3-9
Figure 3.2. General Help Topics
Whenever the projector is not at presentation level, such as when there is a slidebar,
menu, message or test pattern displayed, you have limited time in which to make a
keypad entry before the projector returns to presentation level and the graphic
disappears. These time-outs vary depending on the current display, as shown in the
following chart:
TIME-OUTS
Slidebar (from pres.) 5 seconds
Slidebar (from menu) 15 minutes
Lamp Timer Msg. 30 seconds
Channel entry 5 seconds
Other 15 minutes
A menu item marked with a global icon means that any changes made to that option
are global to the projector and will be applied to all incoming signals.
Most of the sub-menus allow you to change settings by using slidebars, checkboxes,
and pull-down lists. To select a slidebar, toggle a checkbox status, or view a pull-
down list, do one of the following:
• Enter the menu option number corresponding to the setting you wish to change
(for example, press
2
for Size in the Size & Position menu).
Or press
ON
or
OFF
to:
• move the highlight to the desired parameter and press
Enter
.
• move the highlight to the option desired and press or .
• Or bypass menus entirely and use a single key to immediately access an
adjustment (Note: This applies only to options having their own key, such as
Position, Pixel, Bright, and Contrast).
Once selected, change the setting as desired (see below) and press
Enter
to save and
return to the current sub-menu.
SLIDEBARS IN MENUS - The current value for a given
option, such as size or vertical stretch, appears to the left
of its slidebar icon. This number may express a percentage or specific units (such as
pixels, degrees Kelvin, etc.), depending on the option. Press
or to gradually
adjust the setting up or down—both the number and the length of the bar change
accordingly (for continuous adjustment, hold down the desired arrow key). Or press
Enter
to activate a slidebar text box for specific number entry via the keypad, then
press
or and
Enter
to save (or press
Exit
to cancel).
Time-outs '
The Global Icon  '
Using Slidebars and
'
Other Controls