User`s manual

OPERATION
3-56
RPMS, CS50 & CS70-D100U/UF User’s Manual
The specific pattern of flashing indicates the 2-digit code identifying the type of
problem encountered—the number of yellow flashes represents the first digit and the
number of red flashes indicates the second digit. For example, a pattern of “yellow-
yellow-red-red-red” is “Code 23”, meaning the lamp ballast (power supply) is
overheated. These codes are listed in Table 3.2.
Table 3.2. System Error Codes
Code Description
GENERAL
12 Software bug. Contact dealer/factory.
13 CRC error in flash ROM. Download new software.
14 Replace IPM
15 Attempting to download code without being in boot mode
16 Invalid interrupt. Power off/on. If it persists, contact dealer/factory.
LAMP FAILURES
21 Unable to turn the lamp on
22 Lamp driver communications failure (while in dual lamp mode)
23 Lamp ballast (power supply) is overheated
24 Lamp 1 Fault: lamp interlock switch open or color wheel stopped
25 Lamp may be on before being turned on
26 Both lamps failed
27 Unexpected lamp shut-off
29 Lamp 2 Fault: lamp interlock switch open or color wheel stopped
IMAGE PROCESSOR MODULE
31 Boot code CRC failed
32 Unable to program the Sync Xilinx part
33 Unable to program a device on Altera programming bus
34 Unable to program a device on JTAG programming bus
35 Unrecognized ROM type
36 Write to flash ROM failed
37 General IPM failure
38 Code being downloaded will not fit in ROMs
LIGHT ENGINE ELECTRONICS
49 Color wheel stopped
POWER & COOLING
51 Fan #1 failed
52 Fan #2 failed
53 Fan #3 failed
55 Low voltage power supply failed to turn on
56 Lamp shutdown due to fan failure
59 Fan #5 failed
PROJECTION HEAD MODULE (PHM)
71 Unable to access EEPROM on the PHM
72 EEPROM memory has re-initialized
VIDEO DECODER MODULE (INPUT 3 OR 4)
81 Unable to program the video decoder (VDM)
OPTIONAL INTERFACE MODULE
91 Unable to program the option card
92 10-bit ADP boot failure
If you encounter a system error, try resetting the projector by powering it off and on again
(allow proper cooling if necessary). Contact dealer/factory if error persists.