System information

Parts and Module Replacement Christie/Mirage/DLV/Matrix
020-100012-01 Rev. 1 (04/07) 17
Figure 12. Accessing the Contrast Aperture Assembly
Dual Slot Backplane Module (DSBP)
(23 minutes)
The Dual slot backplane module is mounted to the underside of the TIPM. To
remove and replace:
1. Remove the TIPM card
cage. See Card Cage
(TIPM) for instructions.
2. Remove the four (4) self-
taping screws from the
card guides located at the
DSBP. (If you want to
remove the card guides
completely, remove the
additional four (4)
screws from the input
panel.)
3. Remove the six (6)
screws securing the PCB
to the TIPM. (Figure 13)
4. Disconnect the PCB
from the TIPM and
remove.
When replacing, repeat instructions in reverse.
Figure 13. Removing the Dual Slot Backplane
(DSBP)