System information

Christie/Mirage/DLV/Matrix Parts and Module Replacement

18 020-100012-01 Rev. 1 (04/07)

Fans, DMD (1000W and 1200W models only )

NOTE: 500W projector models do not use DMD fans.

(13 minutes)

The blue DMD fan is located directly above its corresponding DMD on the light

engine. It is the most easily accessible DMD fan, in that it does not require removal

of any other components. To remove and replace this fan:

1. Remove the top cover and the protective white nylon cover over the light

engine. See Top Cover for instructions.

2. Disconnect the fan harness and free it from any cable clamps.

3. Remove the four (4) screws securing the fan to the light engine. (Figure 14)

4. Remove the fan assembly.

Figure 14. Location of DMD Fans on Light Engine

(53 minutes)

The red DMD fan is the most difficult of the DMD fans to remove and requires the

removal of the light engine. To remove and replace:

1. Remove the top cover and protective white nylon cover over the light engine.

See Top Cover for instructions.

2. Remove the light engine. See Light Engine for instructions. Once you have

removed the entire optical assembly (light engine and optical mount) go to the

next step. DO NOT

separate the light engine from the optical mount.

3. Remove the four (4) screws securing the fan to the light engine.

4. Remove the fan assembly.

(17 minutes)

The green DMD fan is located directly above the optical tray. To remove and

replace:

1. Remove the top cover and the protective white nylon cover over the light

engine. See Top Cover for instructions.

2. Disconnect the fan harness and free it from any cable clamps.

Blue DMD Fan

Red DMD Fan

Green DMD Fan