System information

Christie/Mirage/DLV/Matrix Parts and Module Replacement
20 020-100012-01 Rev. 1 (04/07)
Fan, Low Voltage Power Supply (Fan 2)
(14 minutes)
The LVPS intake fan is located on the left side of the projector behind the side
intake duct. Its primary function is to blow air through the channel where the LVPS
sits cooling it down.
1. Remove the top cover. See Top Cover for instructions.
2. Remove the three (3) screws from the side intake duct.
3. Remove the two (2) screws securing the LVPS fan and bracket. (Figure 17.)
Figure 17. Accessing the LVPS Fan
4. Disconnect the fan’s harness from the TIPM (P24).
5. Lift the fan and bracket assembly and flip it over to access the back – pull the
four (4) blue rubber isolators off to release the fan. (Figure 18.)
Figure 18. Removing LVPS Fan from Bracket Assembly
When replacing, use the new blue isolators provided in the kit to remount the fan to
the bracket and route the fan harness through the clip located off to the side (on
TIPM baffle).