System information

Christie/Mirage/DLV/Matrix Parts and Module Replacement
24 020-100012-01 Rev. 1 (04/07)
7. Disconnect the AC cable connection from the ballast. The cable can be
accessed through the channel between the ballast and the exhaust duct. (Figure
25.)
Figure 25. Disconnecting AC Cable from Ballast
8. With the fan disconnected and all other harnessing free, lift the exhaust duct
and fan assembly straight up and out of the projector.
9. Flip the exhaust duct over and remove the three (3) screws securing the fan.
(Figure 26.)
Figure 26. Remove the Optical Intake Fan
When replacing, repeat instructions in reverse making sure to route harnesses
back in the same manner. Refer to the Interconnect drawing at the end of this
booklet when re-connecting harnesses.