System information

Parts and Module Replacement Christie/Mirage/DLV/Matrix
020-100012-01 Rev. 1 (04/07) 25
Fans, TIPM (Fan 7 & Fan 8)
(14 minutes)
The TIPM fans are located in the rear left corner of the projector. They are
mounted to the underside of the TIPM baffle. To remove and replace:
1. Remove the top cover. See Top Cover for instructions.
2. Remove the three (3) screws
securing the TIPM cover/baffle
over the TIPM (Figure 27).
NOTE: Fans 7 and 8 are
mounted to the underside.
3. Flip the TIPM cover/baffle over
to access the fans underneath.
4. Disconnect Fan #7 (P31) and/or
Fan #8 (P34) from the Panel
Driver PCB.
5. Each fan is secured to the TIPM cover/baffle with two (2) screws. Remove the
fan you need to replace. (Figure 28.)
When replacing one of these fans,
repeat instructions in reverse.
NOTE: Fan 7 and Fan 8 are the
same type of fan. They are
interchangeable.
Feet
(10 minutes)
There are two (2) adjustable feet on the projector that can be replaced. To
remove and replace:
1. Remove the top cover. See Top Cover – you do not have to remove the white
protective covers located over the electronics. Removing the top cover gives
you better access to the feet.
2. Using a slotted, screw driver, remove the C-clip from each leg. (Figure 29.)
3. Unscrew the foot to remove from the projector.
When replacing, repeat instructions in reverse
Figure 27. Remove the TIPM Cover
Figure 28. TIPM Fans