System information

Parts and Module Replacement Christie/Mirage/DLV/Matrix
020-100012-01 Rev. 1 (04/07) 27
Figure 31. Flex Cable Orientation
To replace any of the LVDS cables, do the following:
1. Remove the top cover. See Top Cover for instructions.
2. Remove the light engine ONLY
if the flex cables for the red DMD need to
be replaced. (60 minutes)
3. Note the P# and J# at the cable ends.
4. Grasp the entire wire set as close as possible to the LVDS cable connector
and pull up gently to disconnect the cables. (Figure 32.)
Figure 32. Properly Disconnecting LVDS Cable
When replacing an LVDS style cable, the connector is keyed to permit insertion
in only one direction (see Figure 32.) Make sure that you connect the proper
cable to the proper connector, i.e., P# matches J#. Make sure to re-route all
cables through the bracket on the HDPD. Allow the cables to loosely loop
around components avoiding sharp changes in direction, which could cause the
cables to kink.
Fold Mirror
(30 minutes)
The fold mirror is located behind the lens mount on the right hand side of the
projector. It is mounted to the optical tray behind the LiteLOC sensor assembly. To
remove and replace:
Gloves
Required