System information

Parts and Module Replacement Christie/Mirage/DLV/Matrix
020-100012-01 Rev. 1 (04/07) 29
Figure 34. Remove Rear Air Filter
3. Remove the lamp. Refer to Lamp Replacement for instructions and
important safety and warning guidelines.
Figure 35. Remove Lamp
4. Remove the cold mirror heat sink (2 - #2 Phillips screws) as shown in
Figure 36.
5. Remove the contrast aperture cover located between the cold mirror heat
sink and contrast aperture motor assembly (2 - #1 Phillips screws). See
Figure 36.
Figure 36. Remove Cold Mirror Heatsink and Aperture Cover
6. Remove the three (3) - #1 Phillips screws securing the black exhaust duct,
which is located just above the lamp compartment (Figure 37.). Remove
the duct from the projector.