System information

Parts and Module Replacement Christie/Mirage/DLV/Matrix
020-100012-01 Rev. 1 (04/07) 31
11. Wearing clean gloves, remove the integrator assembly (integrator and
holder) as shown on Figure 40.
NOTE: Pay particular attention to avoid any contact with the glass rod
itself.
Figure 40. Remove Integrator Rod Assembly
To replace the integrator rod assembly:
WARNING
Integrator alignment must be performed by qualified
service technicians.
1. Air clean the integrator rod assembly before placing it in the optics tray.
2. Carefully lower the integrator assembly into the optics tray with the polished
end of the integrator towards the UV filter (end closest to the lamp
compartment (Figure 40.)
NOTE: the threaded shaft of the assembly should fit into the small slot on the
optics tray.
3. Place the spring clip and standoff over the threaded shaft, but do not tighten.
4. Air clean the integrator rod assembly again.
5. Replace the optics cover on the tray, the green DMD fan, the contrast aperture
cover and the black exhaust duct – do not install the lamp louver or the top
cover. Make sure the DMD fan is connected to the Panel Driver PCB.
To align the integrator:
1. Power on the projector and display a white field test pattern.
2. Adjust the integrator by moving the thumb wheel/standoff up or down (see
Figure 40.) until it fills the DMD and all corners of the displayed image are
filled in (no shadowing) as shown in Figure 41.
Use appropriate
p
recautions while projector
is powered on during
alignment.
Gloves
Required
Gloves
Required