System information

Christie/Mirage/DLV/Matrix Parts and Module Replacement
32 020-100012-01 Rev. 1 (04/07)
Figure 41. Adjust Integrator Rod (A)
Figure 42. Adjust Integrator Rod (B, SX+ pixels shown)
3. When the integrator is successfully aligned, tighten the thumb wheel/standoff
to a torque setting of 2 in-lb to “lock” it in place.
4. Adjust the set screws on the fold mirror using a hex driver to remove any
remaining shadows along the edges. (Figure 43).
Figure 43. Adjust Fold Mirror Set Screws
5. Verify the White Field Test Pattern for any blemishes. If blemishes exist, you
will have to restart the entire process with a new Integrator Rod Assembly.