System information

Parts and Module Replacement Christie/Mirage/DLV/Matrix
020-100012-01 Rev. 1 (04/07) 35
Figure 47. Pull and Turn Lock Lever
4. Grasp the lamp by its housing only and pull it straight out (lamp slides
along guides) until it’s free. (Figure 48.) Discard the lamp using safe
disposal/recycling practices or contact Christie for a possible re-lamping
program.
WARNING
Wear protective gloves when removing lamp.
Figure 48. Lamp Handles
5. Align the new lamp with the top and bottom guides on the left side of the
lamp compartment. (Figure 49.) Slide the lamp all the way in – a slightly
harder push may be required right at the end to make sure it is fully seated
into the terminal block.
NOTE: The projector will not power up again if the lamp is not fully
connected to the terminal block.
Figure 49. Aligning Lamp with Guides
6. Pull (out) and turn the lamp lock lever (turned up in Step 3) a quarter turn
clockwise to “lock” the lamp in place.
NOTE: If you can’t turn the lamp lock into position it is likely the lamp is
not fully inserted. In this case, partially remove the lamp and try pushing it
back in again. Then, try switching the lock lever to the “lock” position.
7. Replace the lamp door and tighten the two (2) screws to secure.