System information

Parts and Module Replacement Christie/Mirage/DLV/Matrix
020-100012-01 Rev. 1 (04/07) 41
Figure 55. Remove Optical Assembly
9. Separate the light engine from the optical mount by removing the three (3)
screws identified by circles in Figure 55.
Handle the light engine by its bottom metal plate and one of the heat sinks.
DO NOT touch any of the boards when removing to prevent damage. See
Figure 56.
Figure 56. Remove Light Engine
When replacing, repeat instructions in reverse. When connecting the cables make
sure to route the blue cables back through the bracket on the TCPD/HDPD and the
red and green cables along the lens mount side. Refer to Flex/LVDS Cables for
more details.
NOTE: It is recommended you replace the Flex cables in your projector if you are
replacing the light engine with a new one