System information

Christie/Mirage/DLV/Matrix Parts and Module Replacement
44 020-100012-01 Rev. 1 (04/07)
When replacing, slide the LVPS under the plate at the back of the LVPS
compartment (Figure 62.), while routing the grey tubing along the side of the
module (Figure 63.). Make sure none of the harnesses from the TCPD/HDPD get
pinched when inserting the LVPS.
Figure 62. LVPS Compartment Back Plate
Figure 63. Inserting the LVPS
Main AC Line Filter
(12 minutes)
The line filter is located next to the interlock assembly at the back of the projector
and is mounted to the bottom chassis. To remove and replace:
1. Remove the top cover. See Top Cover for instructions.
2. Disconnect the three (3) main connections with needle nose pliers.
3. Remove the two (2) screws securing the line filter to the bottom chassis.
(Figure 64.)
4. Remove the line filter assembly. Then separate the line filter from its housing
(two screws).