System information

Parts and Module Replacement Christie/Mirage/DLV/Matrix
020-100012-01 Rev. 1 (04/07) 45
Figure 64. AC Line Filter
Replace a new line filter using the same instructions in reverse.
Optional Input Modules
(5 minutes)
Optional input modules, if installed, are located at Input 5 or Input 6 on the
projector’s input panel. To remove and replace:
1. Remove the two (2) screws from the optional module faceplate.
2. Grasping the module, pull it straight out of the projector.
Projection Lens
(5 minutes)
1. Place a lens cap over the end of the lens to protect it from being damaged.
2. Press and hold the “lens release” button located in the top right corner of the
lens panel. Grasping the lens barrel, turn it in a counter-clockwise direction
until it stops. Then pull it forward to remove it (disconnects from the connector
assembly).
When installing a projection lens, slide the new lens into the lens opening and
at the same time align the connector that is located on the side of the lens with
the connector assembly on the lens retaining ring. As the lens connects, re-
align it slightly until the tabs on the lens fit into the slots in the lens retaining
ring. With the lens fully inserted (and connected) turn it clockwise until the
lens release button “pops” indicating the lens is fully inserted.