System information

Christie/Mirage/DLV/Matrix Parts and Module Replacement
8 020-100012-01 Rev. 1 (04/07)
WARNING
Always power down the projector using appropriate
procedure and disconnect all power sources before cleaning
or servicing.
• All replacement procedures must be performed by qualified projector
service personnel. Read all service instructions before you begin.
• Replace parts with those specified by the manufacturer. DO NOT use
substitute parts.
• When powering down the projector, allow the cooling fans to
automatically turn off (takes approximately five minutes) before
disconnecting AC and removing covers.
• Non-insulated dangerous voltages may be exposed. Always unplug the
projector prior to disassembly.
• Observe and follow all warnings and instructions marked on the
projector.
• Observe all electrostatic precautions. Use a grounded
wrist strap when handling electronic assemblies.
• Ensure the unit is serviced in a clean environment to
prevent dust particles from settling on optical
components.
• Wear supplied protective gloves as indicated by symbol
The exclamation point within the equilateral triangle is intended to alert the user
to the presence of important operating and maintenance (servicing) instructions
in the literature accompanying the projector.
The lightning flash and arrowhead symbol within the equilateral triangle
signifies the presence of non-insulated "dangerous voltage" within the
projector's enclosure that may be of sufficient magnitude to constitute a risk of
electric shock.
It is recommended that you have the following tools on-hand when servicing
any of the parts covered in this booklet.
• Electrostatic protective strap and pad
• Phillips screwdriver #1 and #2
• Slot screwdriver (optional)
• 1/4” Nut Driver
• 3/16” Nut Driver
• 9/16” Nut Driver
• Needle Nose Pliers
• Set of Hex Ball Drivers
3 Safety Warnings
& Guidelines
Tools Required f
Gloves
Required