System information

Parts and Module Replacement Christie/Mirage/DLV/Matrix
020-100012-01 Rev. 1 (04/07) 9
This booklet provides all procedures necessary to replace the serviceable parts
found in the projector. All procedures are listed alphabetically. Refer to the Index
of Parts and Modules on page 4 along with the Projector Exploded View on page 6
to help you identify the parts and where they are located.
Before you begin any procedure, make sure you have read and understood it and
that you are aware of all safety and warning guidelines.
Power off and unplug the projector before performing any of the service
replacement procedures in this booklet.
Use standard ESD precautions.
Refer to the Interconnection Drawing provided at the end of the manual
when reconnecting component and module harnesses.
Removing Projector Covers
(5 minutes)
Removing the top cover is the first step in accessing most of the components in the
projector. To remove:
1. Remove the projection lens. See Removing the Projection Lens.
2. Remove any optional input module installed in Input 5 or Input 6. Refer to the
Optional Input Module instructions later in this booklet.
3. Remove the left side filter door (three screws) and the filter. (Figure 1.)
4. Remove the 17 screws securing the top cover. (Figure 1.)
5. Slowly
, lift the top cover straight up to remove.
NOTE: The front IR sensor PCB is located in the front left corner and can
be damaged if it is hit while removing the cover (See Figure 2 for IR location).
6. With the top cover off, you will see protective shields positioned over the
electronic PCBs and light engine. If required, remove these covers to access
the components underneath.
4 Replacement
Procedures
To
p
Cove
r
f