User manual
Section 4: OPERATION
GS Series User Manual
020-000724-01 Rev. 1 (05-2014)
4-27
- Enter the IP address range, netmask and default gateway for the wire-
less LAN.
• SNMP Panel
- The SNMP (Simple Network Management Protocol) interface provides
network administrators with a common way to manage their network
devices from a single remote location. SNMP allows an administrator to
query a number of devices to see their current status/ configuration. It
also allows operators to change configuration values and configure trap
notifications to be sent when certain events occur. (eg. Loss of signal,
power state change, etc)
Emails are sent to the mail server configured in the projector
settings. Up to 2 user email accounts can be selected. Any
important information regarding the event will be located in the body
content of the email.
SNMP Traps are notifications that are sent from the projector. They
are only received by a trap receiver (MIB Browser) in the computer.
- SNMP Read Community (default setting: private) - this is a plain- text
password. This must also be entered in the MIB browser. This pass-
word allows the various settings in the projector to be queried.
- SNMP Location (default setting: blank) - This field can be used as a
description to where a projector is located in a building. SNMP emails
sent will specify this location.
- Trap IP Address (default setting: 0.0.0.0) - This field must be filled in to
receive Traps from the projector. The Trap IP Address should be filled in
with the IP Address of the computer on which you would like to view
received traps.
- Trap Email 1/2 (default setting: Blank) - The Trap Email 1 and 2 must be
set to an email address that is configured under the mail server that you
will enter in the "SMTP Server IP Address" field.
- Email from Address (default setting: blank) - the "Email from Address"
that will appear as the source of the SNMP emails.
- SMTP Server IP Address (default setting: 0.0.0.0) - Enter your mail
server's IP address.
• Trap Configuration Panel
Set the SNMP actions for the system events. The dropdown options are:
SNMP Trap + Email, Email, SNMP Trap, and Disabled.
• Crestron Control System Panel
Enter the IP address, IP ID, and Port of Crestron device for connection.