User manual

G Series User Manual
020-000648-01 Rev. 3 (02-2014)
Section 3: Installation
3-3
3.3 Turn the Projector On
1. Ensure that the power cord and signal cable are securely connected. The
Power button on the built in keypad is illuminated.
1
2 3 4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20
2. Turn on the lamp by pressing
“ ”
on the remote control or press
“ ”
on
the built-in keypad. The Status LED is yellow with a long blink.
1
2
3 4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20
The startup screen displays in approximately 10 seconds.
3. Turn on the source. Select Input Key on the remote control to select an
input source (VGA, BNC, HDMI, Component, S-Video or Composite
Video).
1 2
3
4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20
4. The projector detects the source you selected and displays the image.
NOTE:

The rst time the projector is used, the preferred language may be selected from the main menu after the startup screen is
displayed.
3.4 Turn the Projector Off
1. Press
“ ”
on the built-in keypad or on the remote control to turn off the
projector. A warning message will appear on the displayed image.
2. Press
“ ”
again to conrm your selection. If you do not press
“ ”
again,
the warning message will disappear after 10 seconds.
Input Key
1 2
3
4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20
Power on
1
2
3 4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20
Status LED
1
2 3 4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20
Power on
1
2
3 4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20