User manual

23
ENGLISH
CCM-LX User Manual
020-000326-01 Rev.1 (10-2010)
Installation and network configuration
How to enter the numbers with the remote control 10-key buttons
During the network address input mode or the network PIN code input mode, some of the
buttons on the remote control are operate as the 10-key input buttons.
1. Select an item with the orange cursor by using the point buttons
!
or , and press SELECT
button
.
2. Select a column with the white cursor by using the point buttons or .
3. Press 0 to 9 key assigned to the buttons to enter the numbers.
* To change the number in a column, enter the number again.
4. After entering the number in the column, press the point buttons or to move the
white cursor.
5. Complete entering the number in the item, and press SELECT button.
6. Repeat steps 1 to 5 for entering all the network address.
 The remote control may differ from each projector.
During the numbers
input mode, these
buttons operate as the
10 key buttons
 The numerical value is a setting example.
Downloaded From projector-manual.com Christie Manuals