User manual

6
Putting batteries
Please load the batteries before using the remote control.
1. Slide back and remove the battery cover.
2. Put the two AA batteries (HITACHI MAXELL, Part No.LR6 or R6P)
into the holder, according to the polarity markings (+) and (-) on the
holder.
3. Put the battery cover back to its former state.
WARNING
►Always handle the batteries with care and use them only as directed. Improper
use may result in battery explosion, cracking or leakage, which could result in
fire, injury and/or pollution of the surrounding environment.
• Be sure to use only the batteries specified. Do not use batteries of different
types at the same time. Do not mix a new battery with used one.
• Make sure the plus and minus terminals are correctly aligned when loading a
battery.
• Keep a battery away from children and pets.
• Do not recharge, short circuit, solder or disassemble a battery.
• Do not allow a battery in a fire or water. Keep batteries in a dark, cool and dry
place.
• If you observe battery leakage, wipe out the leakage and then replace a battery.
If the leakage adheres to your body or clothes, rinse well with water immediately.
• Obey the local laws on disposing the battery.
Remote control (continued)
(1) VIDEO button (2) RGB button
(3) BLANK button (4) ASPECT button
(5) AUTO button (6) POSITION button
(7) VOLUME button
(8) MAGNIFY - ON button
(9) MAGNIFY - OFF button
(10) MUTE button (11) FREEZE button
(12) KEYSTONE button (13) SEARCH button
(14) MENU button
(15) Lever switch : acting 3 functions as below.
Cursor button ▲ : to slide toward the side marked ▲.
Cursor button ▼ : to slide toward the side marked ▼.
ENTER button : to push down the center point.
(16) Cursor button ◄ (17) Cursor button ►
(18) RESET button (19) ESC button
BLANK LASER
ASPECT
ESC MENU RESET
POSITION AUTO
MAGNIFY
MY BUTTON VOLUME
ON 1
MUTE
OFF 2
FREEZE KEYSTONE SEARCH
PUSH
ENTER
PAGE UP PAGE DOWN
STANDBY/ON VIDEO RGB
LASER
INDICATOR
(3)
(1) (2)
(17)
(4)
(16)
(14)
(19)
(6)
(8)
(9)
(11)
(12)
(15)
(18)
(5)
(7)
(10)
(13)
LX400 User Manual - Concise 020-000166-02 Rev. 1 (08-2009)