User manual

4
Connecting power supply
1. Connect the connector of the power cord to the AC
inlet of the projector.
2. Firmly plug the power cor
d's plug into the outlet.
AC inlet
to the outlet
Connector of the
power cord
WARNING
►Please use extra caution when connecting the power cord, as incorrect or
faulty connections may result in fire and/or electrical shock.
• Only use the power cord that came with the projector. If it is damaged, contact
your dealer to newly get correct one.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Never modify the power cord.
Turning on the power
1. Make sure that the power cord is firmly and correctly
connected to the projector and the outlet.
2. Remove the lens cover, and set the power switch to the
ON position (marked “ I ”).
The power indicator will light up in steady orange. Then
wait several seconds because the buttons may not
function for these several seconds.
3. Press the STANDBY/ON button on the projector or the
remote control.
The projection lamp will light up and the POWER indicator will
begin blinking in green. When the power is completely on, the
indicator will stop blinking and light in steady green.
STANDBY/ON button
POWER indicator
WARNING
►A strong light is emitted when the projector’s power is on. Do not look into the
lens of the projector or look inside of the projector through any of the projector’s
openings.
NOTE
• When the AUTO ON in the OPTION menu is set to the TURN ON, and the power was
turned off by the power switch last time, turning the power switch on makes the projection
lamp light on without pushing the STANDBY/ON button. For more information, please
see the “Operating Guide” in the CD.
Power
switch
LX400 User Manual - Concise 020-000166-02 Rev. 1 (08-2009)