User manual

3-6 TVC-1211 User Manual

020-100769-01 Rev. 4 (05-2012)

Section 3: Connecting the Controller

V16A Module

The V16A module (16-input) is installed into the controller to allow connection of S-video, composite sources,

or both. A single V16A module has 16 built-in decoders. Each decoder has 2 inputs, which are the

corresponding inputs from the top connector (A) and the bottom connector (B). Composite video can be

connected to any of the available BNC inputs. To hook up S-video, connect Y (Luma) to the "A" input and C

(Chroma) to the corresponding "B" input. Refer to the illustration below. A single V16A module can connect

up to 32 composite or 16 S-video signal sources simultaneously. Up to 16 simultaneous video windows per

V16A can be opened on the display wall.

D2R2 Module

Up to a maximum of 16 D2R2 modules can be installed into a TVC-1211. For DVI channel configuration refer

to 3.3 Input Channel and Display Numbering, on page 3-4. Each D2R2 has 2 connectors. A DVI source

connected to the top connector is considered Input 1.

V16A

DVI