Operation Manual

17
English
Step 3:
Attach the saddle (29) and saddle support tube (34).
1. Push the saddle (29) with saddle bracket into the saddle slide (30) and
tight it up in desired position.
2. Place the saddle slide (30) into the holder of saddle post (34), set it at
the desired position and screw it onto the saddle support (34) by washer
(32) and star grip nut (33).
3. Push the saddle support tube (34) into the matching locator in the main
frame (1), set it at the desired position and lock it by inserting the bolt with
the quick release (36) in place and doing it up tight. (The setting of the
saddle support can be adjusted easily as desired later through turning
and pulling the quick release (36).) Furthermore, you must ensure when
setting this desired position that the seat pillar is not pulled out of the
main frame further than the highest setting position, which is marked.
Step 4:
Attach the handlebar support (4) at the main frame (1).
1. Place the lower end of the support (4) against the main frame (1) and
push the handlebar cover (14) onto the support (4).
2. Plug the ends of the two computer cable harnesses (11) and (9)
projecting from (4) and (1) together. (Note: The computer cable harness
(11) projecting from the support (4) must not slide into the tube, as it is
required for later steps of installation.)
3. Connect the cable of tension control (15) to the bracket of lower section
cable tension (10) (See figure A1-A4]). Before this step of the installation,
it is advisable to adjust the resistance setting to the position, at which
the cable extends furthest from the sheath. Put the lowest part of cable
(15) into the small hook of lower tension cable (10) (figure A1). Pull it
(figure A2) until the small hook get in higher position (figure A3) and then
insert the cable (15) onto the bracket (10) (figure A4). When joining the
tubes, ensure that the cable connection is not trapped.
4. Put one spring washer (22) and one washer (13) on each screw (12).
Push the screws (12) through the holes in the support (4), screw into
the threaded holes of the main frame (1) and tighten them firmly.