Operation Manual

Step 6:

Attach the computer (28) at handlebar support (4).

1. Put the plug of connection cable (11) into the socket from monitor (28)

backside.

2. Insert the plug of hand pulse cables (20) into the sockets from monitor

(28) backside.

3. Attach the monitor (28) to top monitor bracket of front post (4) by using

screws (18) and washers (19). (Note: When pushing on the computer,

ensure that the cable harnesses are not trapped. Insert the necessary

batteries (2 x Micro 1.5V AAA) under ensure the right polarity into the

battery compartment located on the rear of the computer.)

Step 5:

Attach the handlebar (21) at the handlebar support (4).

1. Place the handlebar (21) against the handlebar support (4) and adjust

so that the hole patterns in the handlebar and the handlebar support

are aligned. Put one spring washer (22) on each screw (23). Push the

screws (23) through the holes in the support, screw into the threaded

holes of the support (4) and tighten ﬁrmly.

2. Push the hand pulse cable (20) thought the holes into the top of

handlebar support (4).

3. Cover the handle bar connection with handlebar cover (24).