Operation Manual

Step 6:

Installation of the ﬁxed handgrip (48) and computer (55) at handlebar

post (19).

1. Put the plug of the connection cable (18) into the socket at the backside

of the computer (55).

2. Place the computer (55) onto the plate at the upper end of the handlebar

post (19) and tighten ﬁrmly with screws (57). (Note: When pushing on the

computer onto handlebar post (19) take care that the cables cannot be

trapped.)

3. Put the plug of the pulse connection cable (50) into the socket at the

backside of the computer (55) and connect with pulse cables (46).

4. Place the ﬁxed handgrip (48) with lower borings onto the threat of handle

bar post (19) in and tighten it with ﬁxing plate (51), washers (39) and self-

lock nut (22) ﬁrmly. (Note: The position of ﬁxed handgrip should have

inclination away from the handlebar post (19).)

5. Put the front and back handlebar cover (53a+53b) onto the upper end

of handlebar post (19) together and ﬁx them with screws (11+26). Hide

the pulse cables as most as possible into handle bar cover (53) and use

cable save (47) to lead the cables.

Step 7:

Attach the AC adapter (56).

1. Please insert the plug of adaptor (56) to the jack (63) of chain guard.

2. Please insert the adaptor (56) to the jack of wall power (230V~50Hz).

Step 8:

Checks

1. Check the orderly installation and function of all bolted and plug con-

nections. Installation is then complete.

2. When everything is in order, familiarise yourself with the machine at a light

resistance setting and make the individual adjustments of the footrests

(31L+31R).

Note: Please keep the tool set, the puller and the instructions carefully

because these may be required later for repairs or spare parts orders.

If you ever remove the covers (58L+58R), observe that these are attached

not only outwardly with the screws (11+61), but also inwardly at the rear

end of the cover with the screws (61).