Operation Manual

Installation instructions

Put everything clearly on the ground and control the comple-

teness based on the assembly steps.

Some screws are already at the mounting locations for an

easy assignment. Assembly time is approximately 30 min.

Step 1:

1. Remove all small parts, loose packing material out of the box

and then take out with help of a second person the base frame

(4) of packaging. Cut the cable ties for removal not yet.

Step 2:

1. Put the right support tube (3) with the inserted connection cable

(73) to the right side of base frame (4) and connect the plug of

the control cable (74) and connecting cable (73). (Possibly the

connector cable (74) has to insert into the support tube.)

2. Insert the right and left support tubes (2+3) to the base frame (4)

(without squeezing a cable) so that the holes pattern and screw

the connection tightly with screws (55) and washers (32).

3. Slide onto the support left and right (2+3) the support covers

left and right (56L+56R) into the correct position.