MSDS

SAFETY DATA SHEET
Date Revised: OCT 2011
Supersedes:
AUG 2011
SECTION I - PRODUCT AND COMPAN
Y
IDENTIFICATION
Christy's® Red Hot Blue Glue®
SYNONYMS:
Christy's® Red Hot Blue Glue® - Low VOC
Christy's® Red Hot Clear® Glue- Low VOC
Christy's® Clear Heavy Bodied Glue - Low VOC
Solvent Cement for PVC Plastic Pipe
SUPPLIER and MANUFACTURE
R
T Christy Enterprises, Inc
655 East Ball Road, Anaheim, CA 92805-5910
Tel. [phone] (North America)
Tel. [phone] (International)
EMERGENCY: Transportation and Medical issues:: Tel. [phone] INFOTRAK
SECTION 2 - HAZARDS IDENTIFICATION
Acute Toxicity: Category 4 Acute Toxicity: Category III Flammable Liquid/Aerosol/Gas: Category 1
Skin Corrosion: Category 3 Chronic Toxicity: Category IV
Skin Sensitization: YES
Eye:
GHS LABEL:
WHMIS CLASSIFICATION: CONTROLLED PRODUCT
CLASS B, DIVISION 2 CLASS D, DIVISION 2B
Highly flammable liquid and vapor May cause allergic skin irritation or rash Do not breath vapor Keep container closed Use in well-ventilated area
SECTION 3 - COMPOSITION/INFORMATION ON INGREDIENTS
CAS# EINECS # CONCENTRATION
Pre-registration Number % by Weight
Polyvinyl Chloride Resin (PVC) NON/HAZ
Tetrahydrofuran (THF) (Stabilized) 109-99-9 203-726-8 05-2116297729-22-0000 45 - 65
Methyl Ethyl Ketone (MEK)* 78-93-3 201-159-0 05-2116297728-24-0000 5 - 20
Cyclohexanone 108-94-1 203-631-1 05-2116297718-25-0000 10 - 30
Acetone 67-64-1 200-662-2 05-2116297713-35-0000 0 - 20
All of the constituents of this adhesive product are listed on the TSCA inventory of chemical substances maintained by the US EPA, or are exempt from that listing.
*This chemical is subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right-to-Know Act of 1986 (40CFR372).
SECTION 4 - FIRST AID MEASURES
Contact with eyes: Flush eyes immediately with plenty of water for 15 minutes and seek medical advice immediately.
GHS CLASSIFICATION:
PRODUCT NAME:
PRODUCT USE:
Hazard Statements
P
recautionary Statements (See Section 15 for all advisory and required precautions
)
Christ
y
's® Red Hot Blue Glue®
Christ
y
's® Red Hot Blue Glue® Low VOC PVC Plastic Pi
p
e Cement
Christ
y
's® Red Hot Clear Glue® Low VOC PVC Plastic Pi
p
e Cement
Health
Christ
y
's® CLEAR Heav
y
Bodied Glue® Low VOC PVC Plastic Pi
p
e Cement
PhysicalEnvironmental
Category 2B
REACH
Skin contact: Remove contaminated clothing and shoes. Wash skin thoroughly with soap and water. If irritation develops, seek medical advice.
Inhalation: Remove to fresh air. If breathing is stopped, give artificial respiration. If breathing is difficult, give oxygen. Seek medical advice.
Ingestion: Rinse mouth with water. Give 1 or 2 glasses of water or milk to dilute. Do not induce vomiting. Seek medical advice immediately.
SECTION 5 - FIREFIGHTING MEASURE
S
Suitable Extinguishing Media: Dry chemical powder, carbon dioxide gas, foam, Halon, water fog. HMIS NFPA 0-Minimal
Unsuitable Extinguishing Media: Water spray or stream. Health 2 2 1-Slight
Exposure Hazards: Carbon monoxide, carbon dioxide, hydrogen chloride and smoke Flammability 3 3 2-Moderate
Combustion Products: Carbon monoxide, carbon dioxide, hydrogen chloride and smoke Reactivity 1 1 3-Serious
Protection for Firefighters: Self-contained breathing apparatus or full-face positive pressure airline masks. 4-Severe
SECTION 6 - ACCIDENTAL RELEASE MEASURE
S
Personal precautions
:
Keep away from heat, sparks and open flame
.
Provide sufficient ventilation, use explosion-proof exhaust ventilation eqiuipment or wear suitable respiratory protective equipment.
Prevent contact with skin or eyes (see section 8).
Environmental Precautions: Prevent product or liquids contaminated with product from entering sewers, drains, soil or open water course.
Methods for Cleaning up: Clean up with sand or other inert absorbant material. Transfer to a closable vessel (Metal or polyethylene [PE])
Materials not to be used for clean up: Liquid(s)
SECTION 7 - HANDLING AND STORAG
E
Handling: Avoid breathing of vapor, avoid contact with eyes, skin and clothing.
Keep away from ignition sources, use only electrically grounded handling equipment and ensure adequate ventilation/fume exhaust hoods.
Do not eat; drink or smoke while handling.
Storage: Store in ventliated room or shade below 27°C (80°F) and away from diirect sunlight.
Keep away from ignition sources and incompatible materials: caustics, ammonia, inorganic acids, chlorinated compounds, strong oxydizers and isocyanates.
Follow all precautionary information on container label, product bulletins and solvent cementing literature.
SECTION 8 - PRECAUTIONS TO CONTROL EXPOSURE / PERSONAL PROTECTIO
N
EXPOSURE LIMITS: ACGIH TLV ACGIH STEL OSHA PEL OSHA STEL:
Tetrahydrofuran (THF)# ## 50 ppm skin 100 ppm 200 ppm 250 ppm
# Mfg. Recommended Allowable Exposure Limit (AEL): 25 ppm
Methyl Ethyl Ketone (MEK
)
200 ppm 300 ppm 200 ppm 300 ppm ## Mfg. Recommended STEL: 75 ppm
20 ppm skin 50 ppm
500 ppm 750 ppm 750 ppm 1000 ppm
Engineering Controls: If ventilated cabinet, enclosure or fume hood is necessary, average airflow should be at least 100 FPM (50.8 cm/sec).
Monitoring: Maintain breathing zone airborne concentrations below exposure limits.
Personal Protective Equipment (PPE):
Eye Protection: Avoid contact with eyes, wear splashproof chemical goggles, face shield, safety glasses (spectacles) with brow guards and side shields,
etc.as may be appropriate for the exposure
.
Skin Protection: Prevent contact with the skin as much as possible.Polyethylene or PVA coated rubber gloves should be used for frequent immersion.
Use of latex/nitrile surgical gloves or solvent-resistant barier cream should provide adequate protection when normal adhesive application
practices and procedures are used for making structural bonds.
Respiratory Protection: Prevent inhalation of the solvents. Use in a well-ventilated room. Open doors and/or windows to ensure airflow and air changes. Use local
exhaust ventilation to remove airborne contaminants from employee breathing zone and to keep contaminants below levels listed abov
e
With normal use, the Exposure Limit Value will not usually be reached. When limits approached, use respiratory protection equipmen
t
Acetone
Component
Cyclohexanone
FileName: Gray 3.20.12 Page 1 of 3