SDS

SAFETY DATA SHEET
Date Revised:
NOV 2018
Supersedes: MAY 2016
SECTION I - PRODUCT AND COMPANY IDENTIFICATION
Christy's® ROOT-BAN™ Drain Pipe Adhesive
SYNONYMS:
Synthetic Rubber Based Adhesive
SUPPLIER and MANUFACTURER:
T Christy Enterprises, Inc.
655 East Ball Road, Anaheim, CA 92805-5910
Tel. [phone] (North America)
Tel. [phone] (International)
Fax: 86 - 21 - 6428 - 1011
Fax: 86 - 21 - 6428 - 1011
Fax: 86 - 21 - 6428 - 1011
EMERGENCY: Transportation/Medical issues: Tel. [phone] INFOTRAC
SECTION 2 - HAZARDS IDENTIFICATION
Skin Corrosion/Irritation: Category 2 Acute Toxicity: None Known Flammable Liquid: Category 2
Eye: Category 2A Chronic Toxicity: None Known
Aspiration Hazard Category 1
Category 3
GHS LABEL: WHMIS CLASSIFICATION: CONTROLLED PRODUCT
Signal Word:
DANGER CLASS B, DIVISION 2 CLASS D, DIVISION 2B
H304 May be fatal if swallowed and enters airways P261 Avoid breathing dust/ fume/gas/mist/vapours/spray
H315 Causes skin irritation
H319 Causes serious eye irritation P271 Use only outdoors or in a well-ventilated area.
H335 May cause respiratory irritation P280 Wear protective gloves/ protective/ clothing/ eye protection/ face protection
H336 May cause drowsiness or dizziness P301+P310 IF SWALLOWED immediately call a POISON CONTROL CENTER or doctor/physician
P304 + P340 IF INHALED: remove person to fresh air and keep comfortable for breathing.
P332+P337+P313 If skin or eye irritation occurs: Get medical advice/ attention
P362+P364 Take off contaminated clothes and wash it before reuse.
P405 Store locked up
P403+P233+P235 Store in a well-ventilated place. Keep container tightly closed. Keep cool
SECTION 3 - COMPOSITION/INFORMATION ON INGREDIENTS
CAS# EINECS # CONCENTRATION
Pre-registration Number % by Weight
Rosin Based Resin 8050-26-8 13-30
Acetone 67-64-1 200-662-2 05-2116297713-35-0000 10-40
Heptane* 426260-76-6 20-60
Globalprene SBS 9003-55-8 5-30
All of the constituents of this adhesive product are listed on the TSCA inventory of chemical substances maintained by the US EPA, or are exempt from that listing.
*This chemical is subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right-to-Know Act of 1986 (40CFR372).
SECTION 4 - FIRST AID MEASURES
Contact with eyes: Flush eyes immediately with plenty of water for 15 minutes and seek medical advice immediately.
Skin contact: Remove contaminated clothing and shoes. Wash skin thoroughly with soap and water. If irritation develops, seek medical advice.
Inhalation: Remove to fresh air. If breathing is stopped, give artificial respiration. If breathing is difficult, give oxygen. Seek medical advice.
Ingestion: Rinse mouth with water. Give 1 or 2 glasses of water or milk to dilute. Do not induce vomiting. Seek medical advice immediately.
SECTION 5 - FIREFIGHTING MEASURES
Suitable Extinguishing Media: Dry chemical powder, carbon dioxide gas, foam, Halon, water fog. HMIS NFPA 0-Minimal
Unsuitable Extinguishing Media: Water spray or stream. Health 2 2 1-Slight
Exposure Hazards: Carbon monoxide, carbon dioxide, hydrogen chloride and smoke Flammability 3 3 2-Moderate
Combustion Products: Carbon monoxide, carbon dioxide, hydrogen chloride and smoke Reactivity 1 1 3-Serious
Protection for Firefighters: Self-contained breathing apparatus or full-face positive pressure airline masks. 4-Severe
SECTION 6 - ACCIDENTAL RELEASE MEASURES
Personal precautions: Keep away from heat, sparks and open flame.
Provide sufficient ventilation, use explosion-proof exhaust ventilation equipment or wear suitable respiratory protective equipment.
Prevent contact with skin or eyes (see section 8).
Environmental Precautions: Prevent product or liquids contaminated with product from entering sewers, drains, soil or open water course.
Methods for Cleaning up: Clean up with sand or other inert absorbent material. Transfer to a closable metal container
Materials not to be used for clean up: Aluminum or plastic containers
SECTION 7 - HANDLING AND STORAGE
Handling: Avoid breathing of vapor, avoid contact with eyes, skin and clothing.
Keep away from ignition sources, use only electrically grounded handling equipment and ensure adequate ventilation/fume exhaust hoods.
Do not eat; drink or smoke while handling.
Storage: Store in ventilated room or shade below 27°C (80°F) and away from direct sunlight.
Keep away from ignition sources and incompatible materials: caustics, ammonia, inorganic acids, chlorinated compounds, strong oxidizers and isocyanates.
Follow all precautionary information on container label, product bulletins and solvent cementing literature.
SECTION 8 - PRECAUTIONS TO CONTROL EXPOSURE / PERSONAL PROTECTION
EXPOSURE LIMITS: ACGIH TLV ACGIH STEL OSHA PEL OSHA STEL:
Acetone 500 ppm 750 ppm 750 ppm 1000 ppm
Heptane 200 ppm 300 ppm 500 ppm
Engineering Controls: If ventilated cabinet, enclosure or fume hood is necessary, average airflow should be at least 100 FPM (50.8 cm/sec).
Monitoring: Maintain breathing zone airborne concentrations below exposure limits.
Personal Protective Equipment (PPE):
Eye Protection: Avoid contact with eyes, wear splash proof chemical goggles, face shield, safety glasses (spectacles) with brow guards and side shields,
etc. as may be appropriate for the exposure.
Skin Protection: Prevent contact with the skin as much as possible. Polyethylene or PVA coated rubber gloves should be used for frequent immersion.
Use of latex/nitrile surgical gloves or solvent-resistant barrier cream should provide adequate protection when normal adhesive application
practices and procedures are used for making structural bonds.
Respiratory Protection:
Prevent inhalation of the solvents. Use in a well-ventilated room. Open doors and/or windows to ensure airflow and air changes. Use local
exhaust ventilation to remove airborne contaminants from employee breathing zone and to keep contaminants below levels listed above.
With normal use, the Exposure Limit Value will not usually be reached. When limits approached, use respiratory protection equipment.
Specific Target Organ Toxicity (Single Exposure)
P331 Do not induce vomiting
P501 Dispose of contents/container in accordance with local regulations.
PRODUCT NAME:
PRODUCT USE:
Health
GHS CLASSIFICATION:
P312 Call a POISON CENTER/ doctor if you feel unwell.
Precautionary Statements (See Section 15 for all advisory and required precautions)
Hazard Statements
P210 Keep away from heat, hot surfaces, open flames and other ignition sources. No smoking
P264 Wash hands thoroughly after handling.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes.
H225 Highly flammable liquid and vapor
Christy's® ROOT-BAN™ Drain Pipe Adhesive
Physical
Environmental
REACH
Component
Remove contact lenses, if present and easy to do. Continue rinsing.
FileName: RH Root Ban Page 1 of 2