SDS

SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
Appearance:
Blue, medium syrupy liquid
Odor: Ethereal Odor Threshold: N/D
P.H. Not Applicable
Melting/Freezing Point: -95°C (-139°F) Based on first freezing component: Acetone Boiling Range: 57°C (133°F) to 67°C (151°F)
Boiling Point: 57°C (133°F) Based on first boiling component: Acetone Evaporation Rate: > 1.0 (BUAC = 1)
Flash Point: -14°C (7°F) T.C.C. based on THF Flammability: Category I
Specific Gravity @23°C ± 2° (73°F ± 3.6°) Typical 0.924 ± 0.01 Flammability Limits:
LEL: 2%
Solubility: Solvent portion completely soluble in water. Resin portion separates out.
UEL: 11.8%
Partition Coefficient n-octanol/water: Not Available Vapor Pressure: 143 mm Hg @ 20°C (68°F): THF
Auto-ignition Temperature: 321°C (609.8°F): THF Vapor Density: 2.49 (Air = 1)
Decomposition Temperature: Not Applicable Other Data: Viscosity: Medium bodied
VOC Content :
When applied as directed, per SCAQMD Rule 1168, Test Method 316A,VOC content is: ≤ 510 gl/l.
SECTION 10 - STABILITY AND REACTIVITY
Stability: Stable
Hazardous decomposition products: None in normal use. When forced to burn, this product gives off carbon monoxide (CO), carbon dioxide (CO2),
hydrogen chloride (HCl) and smoke.
Conditions to avoid: Keep away from heat, sparks, open flame and other ignition sources.
Incompatible Materials: Caustics, ammonia, inorganic acids, chlorinated compounds, strong oxidizers and isocyanates.
SECTION 11 - TOXICOLOGICAL INFORMATION
Likely Routes of Exposure: Inhalation, Eye and Skin Contact
Acute symptoms and effects:
Inhalation: Severe overexposure may result in nausea, dizziness, headache. Can cause drowsiness, irritation of eyes and nasal passages.
Eye Contact: Vapors slightly uncomfortable. Overexposure may result in severe eye injury with corneal or conjunctival inflammation on contact with the liquid.
Skin Contact: Liquid contact may remove natural skin oils resulting in skin irritation. Dermatitis may occur with prolonged contact.
Ingestion: May cause nausea, vomiting, diarrhea and mental sluggishness.
Chronic (long-term) effects: None known to humans
Carinogenicity:
Tetrahydrofuran (109-99-9)
ACGIH: A3- Confirmed Animal Carcinogen with Unknow Relevance to Humans
Cyclohexanone (108-94-1)
ACGIH: A3- Confirmed Animal Carcinogen with Unknow Relevance to Humans
Toxicity:
LD50 LC50
Tetrahydrofuran (THF) Oral: 2880 mg/kg (rat) Inhalation 3 hrs. 21,000 PPM (rat)
Methyl Ethyl Ketone (MEK)_ Oral: 3.98 g/kg (rat), Dermal: 8-10 mg/kg (rabbit) Inhalation 4 hrs. 4,000 PPM (rat)
Acetone Oral: 9.75 g/kg (rat), Dermal: 20 g/kg (rabbit) Inhalation LCLO, 4 hrs, 16,000 PPM (rat)
SECTION 12 - ECOLOGICAL INFORMATION
Ecotoxicity: Category IV
Mobility:
In normal use, emission of volatile organic compounds (VOC's) to the air takes place. Typically at a rate of ≤ 510 Grams/Liter.
Minimal other adverse effects include possible ground water contamination from release to soil, sewers, drains or water course.
Degradability: Biodegradable
BioAccumulation: Minimal to none.
SECTION 13 - WASTE DISPOSAL CONSIDERATIONS
Follow local and national regulations. Consult disposal expert. Can be disposed of by controlled incineration. May be allowed to dry and disposed of as trash.
Excessive quantities should not be permitted to enter drains, sewers or water courses. Empty containers should be air dried before disposing.
SECTION 14 - TRANSPORT INFORMATION
DOT, IATA, ADR, IMO/IMDG SHIPPING INFORMATION
Proper Shipping Name: Adhesives DOT/IMDG EXCEPTION: Case quantities of cement in containers of less than one liter may be
Hazard Class: 3 shipped as LIMITED QUANTITY when properly labeled and marked.
Secondary Risk None ICAO/IATA May be shipped by air as CONSUMER COMMODITY, ID 8000 when
Identification Number: UN 1133 properly packaged, labeled and marked.
Packing Group: II TDG INFORMATION
Label Required: Flammable Liquid TDG CLASS: FLAMMABLE LIQUID 3
SHIPPING NAME: ADHESIVES (TETRAHYDROFURAN)
Marine Pollutant: NO UN NUMBER: 1133, PG II
SECTION 15 - REGULATORY INFORMATION
Precautionary Label Information: Highly Flammable, Irritant Ingredient Listings: USA TSCA, Europe EINECS, Canada DSL, Australia
Symbols: F, Xi AICS, Korea ECL/TCCL, Japan MITI (ENCS)
Risk Phrases: R-11 Highly Flammable
R-20 Harmful by inhalation
R-36/37/38 Irritating to eyes, respiratory system and skin.
R-21 Harmful in contact with skin. R67 Vapours may cause drowsiness and dizziness
R-22 Harmful if swallowed.
Safety Phrases: S-2 Keep out of reach of children. S-24/25 Avoid contact with skin and eyes.
S-7 Keep container tightly closed when not in use. S-29 Do not empty into drains.
S-9 Keep container in a well-ventilated place. S-37 Wear suitable gloves.
S-15/16 Keep away from heat and sources of ignition. No smoking. S-45 If seeking medical advice show physician label or SDS.
S-23 Do not breathe vapor. S-46 Use only in well ventilated areas.
SECTION 16 - OTHER INFORMATION
Specification Information:
Department issuing data sheet: Environmental Health & Safety All ingredients are compliant with the requirements of the European
e-mail address: <[e-mail]> Directive on RoHS (Restriction of Hazardous Substances).
Training necessary:
Yes, training in practices and procedures contained in product literature.
Reissue date / reason for reissue: MAR 2015/ Updated GHS Information
Intended Use of Product: Adhesive for bonding/cementing PVC plastic pipe and fittings
This product is intended for use by skilled individuals at their own risk. The information contained herein is based on data considered accurate based on current state of
knowledge and experience. However, no warranty is expressed or implied regarding the accuracy of this data or the results to be obtained from the use thereof.
Embryotyxicity
Not Applicable
Not Applicable
Not Available
Reproductive Effects
May cause embryofetal toxicity
Teratogenicity
Not Applicable
Not Available
Mutagenicity
Synergistic Products
Sensitization to Product
FileName: RH WET Page 2 of 2