User manual

M8 Plus User Manual 12 V1.3 September 2012
www.chroma
-
q.com
0-5% = No feature
6-15% = Fan off
16-25% = Fan speed 1 (slowest)
26-35% = Fan speed 2
36-45% = Fan speed 3
46-55% = Fan speed 4 (fastest)
56-65% = Gel Saver off
66-75% = Gel Saver on
76-85% = Motor speed normal, see Speed mode (SP)
86-95% = Motor speed fast, see Speed mode (SP)
initialise two
seconds after the
channel level is
entered.
96-99% = Reset (reset to user defaults)
The display shows the current Remote Operation mode of the unit. Press UP or DOWN to increment or decrement the mode
setting.
Summary of control functions:
Operation or
Mode
Operation Description Actions required Display
Power-Up Software version shown
on the unit(s) at power-
up.
This shows the software version while the unit is self-
calibrating, before displaying the ‘Monitor Mode’.
reS
reSreS
reSet This will reset the unit to
the default settings.
While holding down MENU and UP button for 1 second.
P
PP
Power
A
AA
Assisted
L
LL
Loading
(‘PAL-Load’)
Used to load a gel-string
into the unit.
Hold down the MENU button during power-up. Pressing the
UP button will advance the fixed TUR. Pressing the DOWN
button will advance the spring TUR. Press both DOWN & UP
buttons, or cycle the power, to re-calibrate.
See also, gel loading instructions
Modes (Use the MENU button to scroll through these modes)
DMX
addressing
Mode
Used to set the units
DMX data address
The display shows DMX address (1-512).
Press DOWN or UP once to increment or decrement the
value, hold down the DOWN or UP for fast increment or
decrement.
See also, DMX addressing instructions
F
FF
Fan
nn
n speed
Mode
Used to set the fan speed
of the unit.
The display shows the current gel cooling fan speed. There
are four fan speeds, 1 is the slowest and 4 is the fastest.
Press UP or DOWN once to increment or decrement the
value,
See also, fan speed instructions