User's Manual

SC103 Gateway User Manual 2010-08-29
Chromagic Technologies Co., Ltd. Page 19 of 22
CONFIDENTIAL
After the count down, the browser will auto re-connect to the homepage of the
HSC04.
When the firmware is writing to the Flash, the power LED is light on red.
7.5.2. In the Boot Time
In the boot time, if the HSC04 found error image cause to fail boot. The HSC04
will auto into the upgrade mode. At this moment, the connection LED will flash
on green and red.
You can manual to into upgrade mode in boot time, press the reset button, and
then press the connect button over three times, check the connection LED to
make sure the HSC04 into the upgrade mode successes.
Using the browser connect to 192.168.1.222.
Figure 25: The upgrade page in the bootloader runtime.
Choose the firmware file and click the “Mettre a jour” button. It will start to
upload the firmware and write to the flash. It will start to count down. At this
time, the user should not cut off the power of the HSC04.