User's Manual

SC103 Gateway User Manual 2010-08-29
Chromagic Technologies Co., Ltd. Page 3 of 22
CONFIDENTIAL
5.2. Buttons
There are two buttons in the HSC04, one is the reset button (near the dummy
USB socket), and another is the connection button (near the RJ-45 socket).
 Reset Button:
This button will reboot the system. If the system is halting, the user can
press this button.
Note: The HSC04 has the battery power inside, if the DC power be cut off,
it will auto switch to use the battery power. So the device is still halting.
 Connection Button:
 Enable the firmware upgrade function in boot time.
After press the reset button or power on the device, press the
connection button over three times. To ensure the function is enabled,
please check the connection LED is blinking in red and green.
 Set the all settings of the device to the factory default.
After press the reset button or power on the device, press and hold
the connection button until the connection LED is turn on the red and
the green light and after the light are turn off. And then release the
connection button.
 Manual enable the bind function.
After the system is boot up. Press the connection button one time.
 Manual cancel the bind function.
If the system is in the binding mode, Press the connection button one
time.